[stefan.lam]

Hi Angel,

After lowering the speed and rotation, I found that the power supply I use only supports up to .5 A. I remember reading somewhere in the forum that the stepper motors use .8 A. Although the motors are able to move, the distance the parts move do not match the angle it is supposed to be at. Is there a way to adjust things so the stepper motors work with .5 A?

[stefan.lam]

Hi Angel! As a little follow up to this servo motor question, I was a bit confused on the servo connector that’s shown in the ART 5&6 on the Interactive Instruction Manual. Is there a name for this or a link where I can buy this?
Thank you!

[Author]

Posts