Website sections out of sync

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #1997 Quote

      Some sections on the website seem to be slightly out of sync with each other, for example:
      BOM says that you need 7 12V 40x40x10mm fans, but on only 10 are used. says to put 4 40×40 fans in base (step 10/15), but they’re too for small printed base.
      BOM says that only one M5 screw is needed but 5 are used in
      Electronics page mentions 2 sizes of fans, but I only see one size in BOM.
      3D-print page mentions multiple parts that are not used on (Art1OptoFix, Art1FanHolder).

      These are the ones that I remember of the top of my head.

      Any way to know which one is correct?

      Thanks for the great work!

      #2000 Quote
      Angel LM

        Hi Mendy! Thanks for noticing it!

        The 3D viewer on was an early version of Thor v2 and I think is now deprecated, but I’ll check it anyway!

        I’ll review every point you mentioned.

        Thanks for the help 🙂

        #2001 Quote

          Thanks Angel!
          Let me know if you want me to make a more exhaustive list, think I can do that

        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.