Reply To: Art3Body

#1039

Hi Jamie,
as far as i know no one did. I have printed it in a prusaI3. Which is not the tallest printer.Printing this part of thor was fine. I have printed it without support for the roof.My printer has a housing i am unsing ABS a 0.4 nozzle and ABS slurry to glue the part on the glas plate while printing.Temperature bed 110 and nozzle 240.
Only the 90 degrees overhang, where supported.I am not 100% satisfied with my print since the new cooling slots in the roof brought me a litle ;warping during print and the printer motors had lost some steps. I had luck to rehome and restart print at this point.
Maybe someone else is able to recomment a ;better solution.

CU Oliver