[kellers76@web.de]

Hello,
I have what I believe to be an original Mellow board.
https://a.aliexpress.com/_Eu4UPTa
Purchased here.

Strangely enough, it is too large to fit into the constructed housing. Therefore, I am not sure if we have the same board.

I downloaded Asgard from the download area in version V1.0 according to the file name.
Is this version the same as the one in your link?

In the meantime, I have been able to control the board with Pronterface. I wanted to test individual segments and, after installing the configuration, I was able to control all axes in the command line.
So I’m assuming that the board itself is working and that your configuration is correct.

Unfortunately, I don’t see what Asgard is doing for communication with the board and why it’s giving me an “Error: Bad Command” message.

Maybe you have a tip for me on what I can do…

Thanks in advance and huge praise to you, it’s a super cool project!!

Translated with DeepL.com (free version)

[kellers76@web.de]

Hello,
I am very excited about your project and have prepared everything and assembled my Thor.
I am using the recommended Mellow board for the electronics.
My board is called Super 8 HV8-pro.
I am writing to you because I am having a problem with the board and simply cannot get it to work.

I have installed the firmware with the SD card and also transferred the configuration in the form of the “sys” folder to the SD card.
The board seems to have done something with it, as I get the firmware messages in the terminal with M114 and M115.
However, when I try to control the board with Asgard, after connecting, I don’t get an OK, but a constant “Error: Bad Command.”
In between, there are messages with different baud rates, but no communication or OK is established.
Can you possibly help me here?
Unfortunately, I can’t get any further with my options.

Thank you very much in advance.

Translated with DeepL.com (free version)

[Author]

Posts