erolunal

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • May 27, 2023 at 6:21 pm in reply to: Servo motor does not work #2174
    erolunal
    Participant

      I plugged it into pin 7 and it worked. Thank you for your help.

      May 24, 2023 at 8:29 pm in reply to: Servo motor does not work #2172
      erolunal
      Participant

        Thank you for your answers and your interest, I’m at work right now, I’ll try it tomorrow.

        May 23, 2023 at 12:55 am in reply to: Servo motor does not work #2170
        erolunal
        Participant

          It goes to pin 41 on Arduino isn’t it the SIG pin of the servo?

          May 22, 2023 at 9:15 pm in reply to: Servo motor does not work #2169
          erolunal
          Participant

            I installed the GRLB software on 3 different computers, it still gave the same error, the stepper motors work but the servo motor does not.

            May 22, 2023 at 9:11 pm in reply to: Servo motor does not work #2168
            erolunal
            Participant

              5v is coming to the center pin and edge pin of the PT1 pin. I’m typing the same Gcodes. Not working. The problem is most likely in the warnings above.

              May 22, 2023 at 11:51 am in reply to: Servo motor does not work #2166
              erolunal
              Participant

                I am using Tower Pro mg995 servo motor and connect it to PT1 on PCB

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)