grbl-Mega vs AngelLMgrbl

Forum › Get Help › Firmware

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 2, 2020 at 10:24 pm #397
    Erin RobotGrrl

      Hi there Thor community!

      Is there a difference between the AngelLM grbl firmware and grbl-Mega for use with Thor? I see the versions are based on grbl 0.9 and 1.1 respectfully. Would using grbl-Mega have any effect on how Thor works?
      Thanks,-EK

      November 30, 2020 at 10:58 pm #649
      Angel LM
      Admin

        Hi Erin!
        I’m not 100% sure about the 1.1 Version, but there were some differences between grbl 0.9 and Thor’s grbl. The main one is the amount of steppers supported. If I recall correctly GRBL 0.9 supports up to 6 stepper motors and I had to tweak it to add 2 more.
        Hope it helps!Angel LM

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.