fysetc spider klipper

Forum › Get Help › Electronics

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 11, 2021 at 2:41 pm #1719
    P D

      Has anyone tried using the fysetc spider control board and klipper and raspberry pi?

      I am going to try but I do not know if 6 axis motion is possible in klipper or not.

      August 12, 2021 at 7:27 pm #1725
      Angel LM
      Admin

        I didn’t know that board existed, it looks promising. I don’t know anything about Klipper, but in the FYSETC-SPIDER repository there is a Marlin folder inside the firmware one, and I think that Marlin should support 7 axis movement, no?

        Keep sharing your progress with us 🙂

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.