MELLOW

Forum › Get Help › Electronics

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 11, 2026 at 10:29 pm #2451
    ferhatdogus
    Participant

      HELLO. FIRST OF ALL, CONGRATULATIONS. IT’S AN EXCELLENT JOB.

      I WANT TO EXPLAIN THE PROBLEM I EXPERIENCED. I FOLLOWED ALL THE RULES EXACTLY, I CHOSE MELLOW FLY8 INSTEAD OF PCB, BUT THE CARD DIDN’T HAVE A WIFI MODULE ON IT WHEN I ORDERED IT. AND I ORDERED IT BASED ON THE IMAGE I SAW ON YOUR PAGE, AND THE IMAGE REALLY SHOWED A MODEL WITHOUT A WIFI MODULE. I can connect via USB using Termite and Arduino IDE, and the firmware has been successfully installed. However, because it’s Wi-Fi software, it prioritizes connecting via Wi-Fi. Then, it says “failed” and tries to connect to all bands sequentially, but fails. What solution would you recommend for this Mellow Fly8 Pro without a Wi-Fi module?

      March 11, 2026 at 10:31 pm #2452
      ferhatdogus
      Participant

        That’s why I’m getting a “bad command” warning on my Asgard connection.

        March 12, 2026 at 9:12 pm #2458
        Angel LM
        Admin

          Hello, sorry for the delay. Yes, I use the version without the Wi-Fi module, so it should work for you.
          Did you follow all the steps in this guide? http://thor.angel-lm.com/documentation/firmware/#fly-super8pro

          You say you’re using Asgard. I assume you mean this one: https://github.com/AngelLM/Asgard. If so, are you using the FlySuper8 branch version (https://github.com/AngelLM/Asgard/tree/FlySuper8)?
          Let’s see if we can get to the root of the problem!

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.