- This topic has 5 replies, 2 voices, and was last updated 3 months ago by
.
-
Posts
-
Hello everyone. I send files to PCBWay and I want to assembly for Boards. but PCBWay send me an email for confirmation of assembly. Can anyone control the assembly?
https://ibb.co/pdPcCjW
https://ibb.co/NCnMszP
https://ibb.co/Yk3FYxD
https://ibb.co/Csty4p2
https://ibb.co/jvSdcnD
https://ibb.co/1K8dkgy
https://ibb.co/NSGbsQ8Hi! There are a couple of things you should check with the manufacturer:
1. The PDIG1 2×18 male connector should be mounted on the other side of the PCB.
2. The female connectors should not have that gap between the PCB and the connector. They should be fully supported on the PCB. I think it’s because they are using hand-cut 8-pin strips. Instead, I recommend using 32-pin strips, cut only on one side.
3. One of the pins of the PDIG1 connector should be removed and a wire soldered in its place. The pin in question is as follows:
Apart from that, I’ve had a look at it and the rest seems to be fine.
Best regards!Hello,
First of all, thank you very much for your quick response and answer.
I hope to finish the project quickly. Thank you very much for doing this project and making it available for use.Hello again the PCBWAY send me a new pictures for board. and ithink its quite wrong. Could you check , its true? thanks.
- You must be logged in to reply to this topic.